How PV comes on your Roof
Here we show you the typical construction process of a rooftop installation for a single-family dwelling for which the high-capacity modules are optimally laid out by Heckert Solar.
Due to their high stability, especially of the frame and the 4mm solar glass, modules from Heckert Solar are suitable for both vertical and horizontal installation. When doing so, the modules should always be clamped on the long side. In some cases it is necessary to produce a stress analysis for the building.
Make sure that the maximum mechanical load is not exceeded, in particular while also taking the site-dependent loads (e.g. wind and snow) into account. The wind load to be applied must be determined for the project site from the wind zone map which, in addition to wind zones, also takes the situation at the site into account. The snow load to be applied on the ground results from the respective snow load zone, the building site and the elevation above sea level of the property.
You take further information please from our installation & assembly instructions.
